IGLA Giving your car for the maintenance

Service mode

The service mode is used for a temporary deactivation of the anti-theft device when you give your car for the maintenance (without giving away the PIN-code and saying about the device).

For quick activation and deactivation of service mode use the mobile application Author Config.

It is better to activate the service mode before the ignition or the engine is off at the end of the trip.

After the authorization (after the PIN-code is entered) press the service button 5 times. The interval between presses shall not be more than 2 seconds. The activation of the service mode will be confirmed by 5 indication signals .

The service mode can be deactivated in two different ways:

  • Automatically – when you finished driving and the speed during your ride had reached 50 km/h at least once and the car had been in motion at least 3 minutes without stops (or with stops that were not longer than 3 minutes).
  • Manually – via entering valid PIN-code.

The double indication signal will show that the service mode is deactivated.

After the deactivation of the service mode next time the ignition is switched on or the engine is started you will have to use the key fob, smartphone or enter the PIN-code before the ride.

Transport mode

The Transport mode is used for temporary switch off the anti-theft system IGLA and in comparison to the Service mode it can be deactivated only via entering PIN-code.

This mode is used if you want to drive your car for a long time without anti-theft functions (and you do not want these functions to start automatically when you increase the speed). This mode can not be deactivated automatically when the speed is reaching 50 km/h.

In order to activate the Transport mode you need the plastic card with individual Emergency code, hidden under the protective layer. The card is a part of the anti-theft system set.

  1. Switch on the ignition without starting the engine.

    If the IGLA is aligned with the KEYLESS BLOCK module, in order for them to be disarmed by the same key fob, a ten second pause should be taken after the ignition has been turned-on.

  2. Press the brake pedal and while keeping it pressed press the accelerator pedal a certain number of times as far as it can go where the number is equal to the first figure in the secret code. Release the brake pedal. The first figure of the code will be entered.

  3. Input all the rest figures of the secret code in the same way (see item 2).

If the PIN-code is correct, the device will pass into the PIN-code change mode and will give out indication signal every 3 seconds. Press the service button 5 times. The interval shall not be more than 2 seconds. The activation of the service mode will be confirmed by 5 indication signals .

In order to deactivate the Transport mode enter the valid PIN-code. The 2 indication signals will show that the service mode is deactivated.